Hydrogen System HS10000-24V

Hydrogen System for Semi Truck – Save Fuel by 25% and reduce emissions by 78%
Suitable for buses with Diesel engines up to 8 000cc engine displacement and a 24V charging system.
Plug N Play – Easy to install and setup


Hydrogen systems for Semi trucks are easy and quick to install and can be fit­ted to any diesel truck without any engine mod­i­fi­ca­tions or tam­per­ing of the fuel man­age­ment or elec­tri­cal systems.
No com­puter soft­ware, pro­gram­ming, set­ting up, tim­ing or mix­ture adjust­ments are required to the vehi­cle
Fuel-saving sys­tems have built-in: fully auto­matic start, auto­matic stop, and auto­matic safety shut­down con­trol thanks to our Dynamic PWM for diesel 24V, which is included in this system.

Com­pact, easy to install
High qual­ity components
Fully auto­mated Ampere lim­iter built-in
No run-on after shut­down
No backfire possibility
Water level sensor
More than 3000 km. with one refill
Fully automated

Equipped with Dynamic PWM to control the amperes and production of Hydrogen gas depending on many different factors, such as temperatures, density of electrolyte, voltage, resistance, condition of your charging system, battery, etc. There is an LED indicator installed in the driver’s cabin near the dashboard to alarm when the reservoir needs to be refilled.

Most trucks make approximately 15,000 km. per month which at a minimum fuel saving of 2 liters per 100km is equal to 450L. of diesel fuel saving!

Technical Data of the Hydrogen System

Dimensions of the Hydrogen system: H 70cm. X W 50cm. X D 30cm.
Weight: 30kg.

Voltage: 24 – 29 VDC (from vehicles battery)
Material: steel INOX 316L SS
Configuration of the plates: – NNNNNNNNNN + NNNNNNNNNN –
(+ positive, N-neutral, – negative)
Amperage: 3 to 30 Amp
Working surface: 4394 sq. cm
Capacity: up to 4.0 liters of gas per minute
The required ratio of the electrolyte (water-KOH): 5%-15%
Weather and water-proof casing.

The Plug N Play Hydrogen system includes:

HHO Dry cell -1 pc.
HHO tank/reservoir 15 liter – 1 pc.
HHO bubbler – 1 pc.
tubing – 6m.
Red 6 sq.mm. – 3.00 m
Black 6 sq.mm. – 2.00 m
Blue 1.5 sq.mm. – 3.00 m
Automatic fuse  – 30 amps -1pc.
Inlet gas connector – 1pc.
All electrical connectors
Installation instruction + scheme
Instructions for use

Additional information

Weight 30 kg
Dimensions 50 × 30 × 70 cm