- Technical Data
- Package contents
- Additional information
Plug’N Play HHO kits are easy and quick to install and can be fitted to any diesel engine without any engine modifications or tampering of the fuel management or electrical systems.
No computer software, programming, setting up, timing or mixture adjustments are required to the vehicle
Fuel-saving systems have built-in: fully automatic start, automatic stop and automatic safety shutdown control thanks to our Dynamic PWM for diesel 12V, which is included in this system.
Compact, easy to install
High quality components
Fully automated Ampere limiter built-in
No run on after shutdown
No backfire problems
Adjustable power ranges
Water level sensor with buzzer
More than 3000 km. with one refill
Equipped with Dynamic PWM’s to control the amperes and production of HHO gas depend on the engine RPMs. A buzzer can be installed in the driver’s cabin to alarm when the reservoir needs to be refilled.
Most tractors make approximately 300 working hours per month which is saving you a lot of diesel fuel! Besides that, it’s cleaning all the time carbon buildup of some certain parts of the engine and lowers the emissions!
Technical Data of the HHO Generator
Dimensions of the HHO cell: 190 mm x 190 mm x 200 mm (incl. the connectors)
Voltage: 12 – 14.4 VDC (from vehicles battery)
Material: steel INOX 316L SS
Configuration of the plates: – NNNNN + NNNNN – NNNNN + NNNNN –
(+ positive, N-neutral, – negative)
Amperage: 3 to 30 Amp
Working surface: 4394 sq. cm
Capacity: up to 3.5 liters gas per minute
The required ratio of the electrolyte (water-KOH): 5%-15%
#HHO Dry cell -1 pc.
#HHO tank/reservoir 15 liter – 1 pc.
#HHO bubbler – 1 pc.
tubing – 6m.
Red 6 sq.mm. – 3.00 m
Black 6 sq.mm. – 2.00 m
Blue 1.5 sq.mm. – 3.00 m
fuse and fuse holder – 30 amps -1pc.
Inlet gas connector – 1pc.
All electrical connectors
Installation instruction + scheme
Instructions for use
|Dimensions||60 × 30 × 70 cm|